help

Sidebar

RECENT ARTICLES

AWD Front Axle Spacer Measurement and Installation Instructions

13 October 2026

992 GT3RS LCA Inner Installation instructions

15 July 2024

992 GT3/RS Diffuser Ducts Installation instructions

15 July 2024

992 GT3RS UCA Camber Link Installation instructions

15 July 2024

991 GT3RS Valkyrie Wing Instructions

09 February 2024

featured AWD Front Axle Spacer Measurement and Installation Instructions

Installation instructions Rev 1.0 / 10-2026APPLIES TO: AWD 996 / 997 C4, C4S and Turbo, 991.1/991.2 and 992.1/992.2 Carrera 4, 4S, 4 GTS and Turbo/Turbo S with our 15 mm Front Axle Spacer Kit (403-10035). *IMPORTANT – DO NOT INSTALL UNLESS MEASURED*The spacers are included with our AWD and Turbo/Turbo S suspension packages in case your car needs them. Many cars do...

On by Dundon Motorsports

Read more
992 GT3RS LCA Inner Installation instructions - Dundon Motorsports

992 GT3RS LCA Inner Installation instructions

Installation instructions Rev 1.0 / 07-2024NOTE: Installation process is more involved than with 991 or 997 carsREQUIRED STEPS BEFORE INSTALLATION PROCESS: ▪ Remove wheels. ▪ Remove front under-panel. This requires...

On by Alex Osadchuk

Read more

992 GT3/RS Diffuser Ducts Installation instructions

WHAT IS INCLUDED? 1. Remove diffuser from the car 2. Prepare Dundon 992 GT3/RS Diffuser Ducts for installation 3. Put 992 Diffuser Duct – Main Body (RIGHT) on the metal duct 4. Put 992 Diffuser Duct – Cap (RIGHT) on the metal duct 5. Put and fasten 3x M5 bolts 6. Put 992 Diffuser Duct – Main Body (LEFT) on the metal...

On by Alex Osadchuk

Read more

992 GT3RS UCA Camber Link Installation instructions

1. Remove wheels. (Figure 1.).2. Remove Nut (A – Figure 2.) and Eccentric (B – Figure 2.). (Leave Camber Eccentric bolt installed – Figure 3.). 3. Remove Nut from UCA Connection (E – Figure 2 / Figure 3.). 4. Remove bolt from UCA Connection (D – Figure 2 / Figure 3.). 5. Allow knuckle to lean away from shock – as shown...

On by Alex Osadchuk

Read more

991 GT3RS Valkyrie Wing Instructions

    REMOVE OEM Rear Wing   REMOVE OEM Wing Uprights (save M6 bolts for later)USE HAND TOOLS. IMPACT WILL PULL OUT INSERTS REMOVE cooling fans (then remove two connectors underneath fan)   REMOVE right trim cover, unplug connector under the cover   REMOVE Oil Fill Cap & Coolant Fill Cap (If engine is hot, you can remove the trim on the...

On by Alex Osadchuk

Read more

Sway Bar End Link Installation and Adjustment

991 FRONT 1. Remove Front OEM sway bar links. 2. Install new Dundon Motorsports end links. Torque large M12 bolt and nut (using the nut-side) to 90Nm. 3. Lower Rod end will now sit on the opposite side as OEM. 4. The rod end will now be on the OUTSIDE or the wheel side of the sway bar. 5. Final torque for M10 bolts...

On by Alex Osadchuk

Read more